Placa WIF no RED HAT

[elder35]

ESTOU TENTANDO INSTALAR E CONFIGURAR UMA PLACA WIFI NO RED HAT ENTERPRISE V.4.

MAS NÄO ESTOU CONSEGUINDO CONFIGURAR CORRETAMENTE.

ESTA DANDO AS SEGUINTES MANSAGENS:

ALGUEM SABE COMO INSTALAR ESTA PLACA OU RESOLVER ESTE PROBLEMA?

EU ESTOU TENTANTO INSTALAR ESTA PLACA COM O ndiswrapper.

iwconfig -->

lo no wireless extensions.

eth0 no wireless extensions.

sit0 no wireless extensions.

Warning: Driver for device wlan0 recommend version 18 of Wireless Extension,

but has been compiled with version 16, therefore some driver features

may not be available...

wlan0 IEEE 802.11b ESSID:off/any

Mode:Auto Frequency:2.412GHz Access Point: 00:00:00:00:00:00

Bit Rate:11Mb/s Tx-Power:20 dBm Sensitivity=0/3

RTS thr:2432 B Fragment thr:2432 B

Encryption key:off

Power Management:off

Link Quality:0 Signal level:0 Noise level:0

Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0

Tx excessive retries:0 Invalid misc:0 Missed beacon:0

dmesg -->

ndiswrapper version 1.8 loaded (preempt=no,smp=no)

ndiswrapper: driver netdlwl (D-Link,05/23/2003,5.140.0523.2003) loaded

ACPI: PCI interrupt 0000:00:0f.0[A] -> GSI 3 (level, low) -> IRQ 3

ndiswrapper: using irq 3

divert: allocating divert_blk for wlan0

wlan0: vendor: 'D-Link Air Wireless LAN Adapter '

wlan0: ndiswrapper ethernet device 00:11:95:21:04:43 using driver netdlwl, 1186:3300:1186:3301.5.conf

wlan0: encryption modes supported: WEP

lspci -->

00:04.0 Ethernet controller: Silicon Integrated Systems [siS] SiS900 PCI Fast Ethernet (rev 91)

00:0e.0 Communication controller: Agere Systems V.92 56K WinModem (rev 02)

00:0f.0 Ethernet controller: D-Link System Inc DWL-510 2.4GHz Wireless PCI Adapter (rev 20)

01:00.0 VGA compatible controller: nVidia Corporation NV18 [GeForce4 MX 4000 AGP 8x] (rev c1)