Erro na troca de mini pci wireless(dv6000)

[natxy]

Olá,

Peguei uma mini pci pra trocar pela minha, só que na hora que ligo o note da o erro:

104-Unsupported wireless network device detected. System Halted. Remove device and restart

Encontrei um tutorial em inglês:

First off if you don't have linux installed you will need to go to www.knoppix.org and download KNOPPIX_V3.8.2-2005-05-05-EN.iso, then burn the cd

You need to have the card install during the boot sequence so, have your laptop open and bootup, when you see the boot:_ line insert the card then press enter. Knoppix will autodetect the card & the bios wont complain.

Once knoppix has booted:

Click on the penguin on the taskbar and select "Root Shell", then the following command (from now on any line that begins with a # is a command to be typed at the Root prompt:

#iwconfig

You will get a list of ethernet adapters, eth0, eth1 etc. The wireless one should be quite obvious from the text displayed after it with all the wireless parameters!

#ethtool -e ethX

Obviously replace the 'X' with the index of your wireless card you found above.

You will get a hex dump of the 256 bytes of EEPROM data.

Note: There is nothing dangerous in the above steps at all.

If you want to writing to your EEPROM (You can seriously screw your card up so be careful ):

#mkdir /usr/tmp

#cd /usr/tmp

#wget http://www.geocities.com/sonyirclib/ipw2200.tar.gz

>

N.B. This file has already been patched to allow writing to the eeprom

#tar xvzf ipw2200.tar.gz

#cd ipw2200-1.0.3

#sh unload

#sh load

Now all that you need to do is write to the eeprom. If your card is from Europe:

#ethtool -E eth0 magic 0x2200 offset 0x8 value 0xf6

#ethtool -E eth0 magic 0x2200 offset 0x9 value 0x12

#ethtool -E eth0 magic 0x2200 offset 0xa value 0x3c

#ethtool -E eth0 magic 0x2200 offset 0xb value 0x10

If it is from the US:

ethtool -E eth0 magic 0x2200 offset 0x8 value 0xf5

ethtool -E eth0 magic 0x2200 offset 0x9 value 0x12

ethtool -E eth0 magic 0x2200 offset 0xa value 0x3c

ethtool -E eth0 magic 0x2200 offset 0xb value 0x10

N.B. the -E must be uppercase for writing to work.

Now reboot your computer and you should no longer get the error 104...!

Só que na hora de rodar esse linux ae, fica na tela onde tem um pinguim, tipo um prompt mas nao sai mais dali.

Alguem da uma Luz?

[natxy]

up up up up